Archery Talk Forum banner

How do you tell When a Bow is Perfectly Tuned

1K views 16 replies 14 participants last post by  Macdoc18 
#1 ·
For me its when a fletched arrow shots trough a free hanging(nothing holding bottom or side just hanging ) sheet of typing paper and the paper dose not move as the arrow passes trough and you get a perfect hole thats how all my bows are tuned and any broadhead I shot flays like a guided missile
 
#3 ·
I’m with you on the paper tuning. I’ll start off by squaring my rest and nock point, then move to paper tuning, with both a fletched arrow and bare shaft. Then I’ll move to target practice with fletched arrows and a bare shaft just to make sure my bare shaft is grouping with the fletched ones and hitting the target square (not only does this help bow tuning, but also with practicing your shot sequence and follow through), then it’s on to broadhead tuning with fixed blades. Once I have my broadheads hitting with my field tips, then I’m satisfied. I used to think that it was impossible to get fixed blade heads to group with field tips, then I actually learned how to tune a bow and set up an arrow the right way


Sent from my iPhone using Tapatalk
 
#4 ·
quite simply,...the better tuned your bow is, the more forgiving it will be. most people pay attention to the good, well executed shots and dismiss the shot where they know they made small mistakes. as you tune , do just the opposite,.... pay attention to the results you get on shots that you know you made small form or execution errors. when they start going in as well as the well executed shots, your bow is getting close to being tuned as well as it can be.
 
#5 ·
I start with BS tuning to get it all close, but when I get my fixed blade BH's hitting exactly the same as my FP arrows at 60 then my bows shoot extremely well at all distances.
 
#7 ·
Well, a well tuned bow is one that has been tuned with someone who can shoot well. But then, you don't have to have a well tuned bow to hit what you want if you're up to it. Okay, you have to be "tuned" better than the bow.......

Some say that a target point and fixed broadhead hitting together is that of a well tuned bow. Some say a fletched shaft and bare shaft hitting together at 20 yards is that of a well tuned bow.

My bows are tuned when they hit where I want them to...........
 
#9 ·
when my bow is tuned. as long as the arrow is not underspine. I can shoot any spine with any tip weight and get a bullet hole or damn near with a bare shaft at 20 yards.

that means if a 350 spine is weak with a 300gr tip then I can shoot that arrow with a 250 to 100gr tip or any configuration with a 300,250,200,150 spine arrow with minor adjustments. test height do to arrow OD changesor nock tuning.
 
#10 ·
Where do you stop tuning? I thought I had a well tuned bow, but I tried Torque Tuning and found it worked. Maybe not for everyone and then maybe not everyone needs to torque tune.
 
#13 ·
It’s a lot like asking when is you rifle “accurate enough”. Will one inch groups do when you can get it to 3/4 groups? Will 3/4 groups do if you can get it to 1/2 inch groups? When it will consistently do what you want it to do, when you do your part, it is tuned enough for the job you want it to do.
 
#14 ·
I don’t know about perfectly tuned, but I stopped tuning my hunting and long range bow when it became capable of baseball sized 5 arrow groups at 100 yards and gave me all the forgiveness I could wring out of it.

At that point, I refused to touch anything else. I don’t care what new idea I have, I try it on a different bow, that one is done. I have done nothing other than change the center serving in a year on that bow, and then I took super meticulous notes and measurements.

I care about grouping and forgiveness. I use torque tuning, bareshaft, and line tuning to get there, but the measurement that matters is how well it shoots. I believe my bow now shoots the bareshaft a little low and left now after the tuning, who cares. I swap sights when it’s time to hunt and that sight is sighted in to the broadheads and it pounds.

My target rig, I haven’t been happy with it’s performance in a long time. I’ll keep tuning it until it gets to the point that it shoots as good as I think it can. If it doesn’t get there in the next 12 months, I’ll be moving on.

D
 
#16 ·
"I swap sights when it’s time to hunt and that sight is sighted in to the broadheads and it pounds."

Pete Shepley, Mr PSE, has said the above more than a few times. I believe if your broadhead is accurate and consistent you shouldn't have to worry about target point arrows until it's paper or 3D time......
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top