Archery Talk Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter #1
I'm going back to Alum and need to change to a large bisquit. I have the new model, 2009, and can't figure how to get the old one out and insert the new one. Trophy Ridge doesn't list a phone number on their website for me to call.
Hopefully someone can tell me how to change the bisquit or provide a phone number to TR.
 

·
Registered
Joined
·
3,341 Posts
http://www.trophyridge.com/contact/

To contact Trophy Ridge directly:
Trophy Ridge
817 Maxwell Avenue
Evansville, IN 47711
Phone: 812-467-1200
Fax: 812-467-1300




Customer Service:
Phone: 800-694-9494
Fax: 812-425-1425
[email protected]




For repairs:
Please call customer service at 800-694-9494 for a repair number and send equipment to:

Trophy Ridge
Attn: Service Department
4600 SW 41st Blvd.
Gainesville, FL 32608
 

·
Registered
Joined
·
2,614 Posts
I had the same question and the response I got was to loosen the two small set screws remove rubber end caps and take a diagonal cutter and cut the old one out. When finished push the new one into the groove kinda like a keyring and tighten set screws.
 
1 - 3 of 3 Posts
Top