Archery Talk Forum banner

Hoyt cams (XTR)

434 Views 4 Replies 4 Participants Last post by  SierraMtns
I have a Hoyt Turbohawk with XTR cam and 1/2. The bow is set at 27 inch DL. My question is, the draw stop pin is set on C is that right for my DL. Are the other letters for longer DL?

Thanks
1 - 5 of 5 Posts

· Registered
Joined
·
5,756 Posts

· Registered
Joined
·
22,716 Posts
Easy way to tell is to look at the numbers on the modules. Say for instance it said, 2D. That means you have a #2 cam and a D mod. So then the stop goes in the D hole.
 

· Registered
Joined
·
2,672 Posts
Discussion Starter · #5 ·
C is 27" on my #2 xtr's. I find them running almost 1/2" long though on the Maxxis.
Its funny you say that because it feels a little long compared to the old Bear bow. When I anchor back the sting is a little back from the tip of my nose. Might need to take it to the shop and have it shorted up to 26.5
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top