Archery Talk Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
I am shooting a Hoyt Magna Tec and I am having problems with vibration noise in the Hoyt 2 piece quiver. All bolts are tight and I have put a Limb Saver noise reducer on it. Any suggestions?
 

·
Registered
Joined
·
34,166 Posts
It just the nature of the beast. Two piece quivers are just noisy for the most part. The best thing to do is to use a one piece quiver and take it off once you get in the tree or blind. Or use a hip quiver. Plus your bow will balance better with no quiver on it while shooting.
 

·
Registered
Joined
·
907 Posts
Same problem

I had the same problem today. The vibration showed up after I put my arrows in the quiver. I pushed the arrows further into the foam and the vibration went away.

If you have arrows in your quiver......I bet this is the problem.:wink:
 

·
Registered
Joined
·
5,101 Posts
Just put a new 2 piece hoyt quiver on my protec and it doesn't make any noise yet, actually a very quiet setup. Sounds like limbsavers on the hood would help it some.
 
1 - 4 of 4 Posts
Top