So my press finally came in, installed it last night and started putting it to work this morning. I'm shooting an RX7 Ultra at 71lbs, 29.5" draw length. Before I had access to a press I was shooting BH about 6 inches to the left of FP at 30yrds. When I would shoot through paper at around 9-10ft I was getting a high right tail tear. My centershot is 13/16ths, I would like to leave it that way if possible. I raised the arrow rest and I am pretty close to center now when shooting fletched through paper, tail is still a tad high as you can see from the picture. BUT when I shoot a bareshaft I am consistently hitting tail low.
My issue is my bareshafts are hitting tail low when my fletched are hitting tail high. The same thing occurs when I shim the cams. I get a bullet hole when shimmed hard right on both top and bottom BUT with fletched I am tail right...... Do I tune for bareshaft and forget the fletched?
New tuner at a loss on what to do.....
All my shots are consistent like this, I changed the paper so I could give you guys a clear picture instead of 30 holes.