[Rgarbarino]

Haven't shot my bow in a little bit and when I did seemed like my tune was a little off. Did a little work on cam sync and reset my nocking point to level with the berger hole. Shot through paper with a fletched and bare shaft. I got the tear level with both shafts but still had a little tail right tear. So off I went to the range and shot from 20, 40 and 60. Fletched arrows hit nice and vertical to a plumb bob I hung on the target. Then I shot a fletched shaft and a bare shaft a few times and had good results. Went out to 40 yards with fletched and bare shafts and consistently got this result, that center is a 2" dot. Sure they are not stacked right on top of each other but that's just my shooting.

Who would be satisfied with this result?

 

[Rgarbarino]

Thanks for the input. Just goes to show you don't "have" to have a perfect bullet hole in paper to get good results down range. After my retune I was definitely getting better 6 arrow groups at 60 and 70 yards.

 

[Rgarbarino]

This is a good idea of a guy that didn't go OCD on paper, and simply went to a more effective tuning method without wasting a bunch of time.

Arrows downrange tell the true story!

 

[Rgarbarino]

If you can do that a couple times I'd call it good!

Had consistent results like this, shot the same at 40 yards 5-6 times then I stopped.