Archery Talk Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
843 Posts
Discussion Starter #1
Would anyone who uses a LW 1 sight (mine is razor pin, .019) have a suggestion for securing the fiber within the pin body so it does not move front to back (without ruining the fiber, of course). My fibers are about 1/2" or so and constantly move back & forth through the sight pin body. This is irritating, especially on the longer distance pins. Shortening any more than they are would likely cut down severely on the brightness.

If anyone has a remedy, I`d appreciate hearing it. Thanks.
 

·
Banned
Joined
·
910 Posts
you see a few on the 3D circuit shoots and when i ask them , how they like it, they say they wish they bought a spot Hogg. Sureloc makes a great target sight, but theyre missin it for a high end pin sight. Thats a common problem...solution???
 

·
Registered
Joined
·
885 Posts
I've used just the smallest speck of superglue right where it meets the pin, and it seemed to work ok. Maybe bow wax would hold it too.
 

·
Registered
Joined
·
36 Posts
Man, I just ordered razer pinns too... I guess I will be gettin out the old super glue. If I think of anything else along the way I will let you guys know.
 
1 - 4 of 4 Posts
Top