Archery Talk Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
589 Posts
Discussion Starter #1
Does anyone know the difference in the pro model? Are they all pro models now?
 

·
Registered
Joined
·
11,379 Posts
Does anyone know the difference in the pro model? Are they all pro models now?
All the new ones are pro models.. so yes, they are all pros now.

The older style had a block that fit tight up against the backside of the riser.

The new ones have better adjustments too.
 

·
Registered
Joined
·
589 Posts
Discussion Starter #3
When did Vapor Trail start putting "Limb Driver" above the adjustment marks? Did this just start in 2010 or was it also in previous years?
 

·
Registered
Joined
·
11,379 Posts
When did Vapor Trail start putting "Limb Driver" above the adjustment marks? Did this just start in 2010 or was it also in previous years?
the "limdriver" laser etched models are 2010's. They machied the adjustments a bit better and beefed up the shaft, in case they get installed improperly( the launcher is not supposed to be pressed into the shelf super hard while the rest is in the "down" position)
 

·
Registered
Joined
·
6,481 Posts
the "limdriver" laser etched models are 2010's. They machied the adjustments a bit better and beefed up the shaft, in case they get installed improperly( the launcher is not supposed to be pressed into the shelf super hard while the rest is in the "down" position)

VT told me they beefed up the shaft and put flats on them because with bows like the Omen and Monster they were still getting shafts slipping even with the new cup screws.
 

·
Registered
Joined
·
589 Posts
Discussion Starter #6
Thanks for the replys.
 
1 - 6 of 6 Posts
Top