[EricO]

One side of the factory grip on my allegiance has been loose for quite some time. It's not a world ending problem, but it was very annoying. I was shooting yesterday and near the end of the session I made a bad decision to pull (tear) it off. After that I liked the feel of the bow, but I think I need some type of grip on the bow to be shooting in the same form I was. I have searched on here and decided on the shrewd grip. I ordered it from Lancaster this morning. Will this new grip be approximately the same thickness as the Bowtech Factory grip?


Thanks,

EricO

 

[Earl]

I do not know about the thickness but that thing will be cold on those morning hunts. I would have found a wood one

 

[EricO]

I do not know about the thickness but that thing will be cold on those morning hunts. I would have found a wood one

I'm pretty much physically modeled after my avatar, so I stay warm almost all of the time :embara: I'll have on gloves, but I guess I'll see when it gets here. If it ships today I should see it by Friday.