Archery Talk Forum banner
1 - 20 of 25 Posts

· Registered
5,078 Posts
If you are using the rear 1/4-20 hole check to make sure the threaded hole is perpendicular to the mounting surface.
I know its not on the contender elite/contender.

Have no idea why it would be off, but its off about 10° to the flat that is machined on riser around it.
Confirmed on three of my contenders when bolting a rear stab bracket on.
1 - 20 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.