[caribouhunter30]

Hello Guys I'm new to AT and need some help. I recently purchased a Ross 334 and put a NAP smart rest on it. I love the feel of this bow I shot Hoyt's for about 20 years and just hated the cam and a half system. My problem is that when paper tuning I have a nock left tear of about 1 1/4" and no matter how far left I move the rest it does not help. I'm shooting a 27 1/2" draw length at 60 lbs. using a 26 1/2" Easton 400 FMJ with 100 grain points. I think the problem is the arrows are a size too stiff. I will be shooting about 63lbs. for hunting and hopefully that remedies the tear issue. I only was able to shoot at 20 yards so far and my groups were about a 1/2". Any suggestions?

 

[red44]

If your using a release, try moving the rest to the right.

 

[GRIM]

Paper tune it at 6 ft. If it is a left tear,move your rest towards the riser, not away from it. If you get to the point that it is to close, you will have to yoke tune it. I automatically set ata on arrow side 1/16 less ,no more and paper tune from there, usually end up around 21-22/32 from riser and fixed shoot the same as field points.

 

[caribouhunter30]

Thanks Guys I will try that this weekend.

 

[pblawler]

Tuning Procedure