Archery Talk Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
I bought an Octane 2-piece quiver for my Bowtech Experience and it does not seem to fit.
The quiver screws have a triangle piece on them that looks like some sort of additional cap.

20140201_090636.jpg

It looks like I can maybe get the triangle piece off, but before I tried I wanted to get some feedback.
Thanks for any help!
 

·
Registered
Joined
·
43 Posts
Discussion Starter #2
The first black triangle piece closest to my hand pops off with a little force, and now it fits perfectly.

I think the triangle piece is a mod to fit on a hoyt?
 

·
Registered
Joined
·
195 Posts
On the older 2 piece quiver I have on my Experience the fitting bars are octagonal and come with a black octagonal spacer to set the quiver a bit further away from the riser if the arrows interfere with the sight or rest
 

·
Registered
Joined
·
9,731 Posts
Ya the triangle piece is for other bows. Shoud be a plastic washer with a shoulder that goes in the hole on the non quiver side of the bow as well.
 
1 - 4 of 4 Posts
Top