Archery Talk Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
534 Posts
Discussion Starter #1
Trying to paper tune my Mathews Heli M (single cam bow). Keep getting a hard right tear. Bow is 28" draw, 60-70, bow specs are good. String/cable was replaced last September. I have adjusted rest and tried different spines arrows ( 27.5"-28.5" GT 400 and 340 spine) . No rest contact. No facial contact. No matter what I do still get right tear.
Is the next option yoke tuning?
Any suggestions would be appreciated.
Thanks in advance
 

·
Registered
Joined
·
29 Posts
You checked center shot and nock point.? Mine will shoot bullet holes. Use a bow square and set arrow centered on Berger hole and level, then set rest (up-down) then check center shot.
 

·
Registered
Joined
·
534 Posts
Discussion Starter #4
You checked center shot and nock point.? Mine will shoot bullet holes. Use a bow square and set arrow centered on Berger hole and level, then set rest (up-down) then check center shot.
I set it up level and eyeballed center shot.
What measurement works for your center shot?
 

·
"Keep Hammering"
Joined
·
8,064 Posts
Yes you can yoke tune the tear ouy of it. Set the centershot at 3/4-13/16 first. Add twists to the right side yoke leg and remove from the left yoke leg.

Sent from my SM-G930V using Tapatalk
 
1 - 6 of 6 Posts
Top