[Benjamin59]

I’m gonna advance the timing on the top can but anyone have their cables touch at full draw?

 

[Benjamin59]

So turns out after tearing the bow apart and trying a lot it was the arrow smacking the containment bar I took it off and bingo! Kinda off because it was bareshaft too

I shot bareshaft and fletched at 18 and almost touching in good.
This is what it was

 

[168p&y]

Thanks for update. I'm new to pse so I ve been reading everyone's post. Glad to see it was the rest.

 

[Benjamin59]

Thanks for update. I'm new to pse so I ve been reading everyone's post. Glad to see it was the rest.

Love this mach 1!! Fast and light

 

[spike camp]

So turns out after tearing the bow apart and trying a lot it was the arrow smacking the containment bar I took it off and bingo! Kinda off because it was bareshaft too

I shot bareshaft and fletched at 18 and almost touching in good.
This is what it was

Which rest are you using?

 

[Benjamin59]

Qad mxt

 

[spike camp]

Qad mxt

Assuming the MXT has the same configuration as the HDX, the reason i asked is because if you were getting contact with the containment bar...I’d be looking for the root of the cause of the contact, instead of just removing the bar.

 

[Benjamin59]

So I went and did a full reset afterwords

adjusted the top cam to hit first maybe 1/8 before the bottom
Set the arrow thru the Berger
Redid my d loop so it didn’t have nock pinch

So far doing good