Archery Talk Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
15,839 Posts
Well, I thought it was hard to use and I had very limited accuracy with it. It went on Ebay a few years ago. I use a No-Peep on my last hunting bow with very good results, but I am going to try an Anchor Sight on the next.

I have no doubt the Anchor Sight is better, but I am not sure how much it will cludder up the sight window or not.

As far as I am concerned the Hind sight is junk.
 

· Registered
Joined
·
311 Posts
I used a hindsight with my large peep (1/4inch) for bow torque. So pretty much if I think I'm torqueing the bow, I'll put it on. Once I'm settled down again I take it off. I have the hindsight that sits on the cable guard. With sight pin guards, the hindsight blocks much of the sight window that I decided I really didn;t like it. I tried no-peep as welll, and found it difficult to adjust. I have heard the Anchor sight is easier, but more expensive. YOu need to take a lot of time adjusting from a peep to a no-peep setup.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top