Hello folks, I'm currently tuning my mach 30 with ec2 cam and realizing my draw length is maybe 1/4" too long. I was planning to just go down to 29" from 29.5" but I noticed the EC2 cam has these little adjustments on the draw stop. I can't find any documentation on pse bows or cams at all, are these letoff adjustments?
If so, or if not, it seems like they're obviously moving the position of the draw stop by like 1/8-1/4 of an inch, because the stop moves and the screw stays in the same hole, I could probably just tune my draw length to around 29.25" by moving this, right? Am I missing anything here?
If so, or if not, it seems like they're obviously moving the position of the draw stop by like 1/8-1/4 of an inch, because the stop moves and the screw stays in the same hole, I could probably just tune my draw length to around 29.25" by moving this, right? Am I missing anything here?