Archery Talk Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,844 Posts
Discussion Starter · #1 ·
For those of you guys shooting the new source are you having the cables stops and the limb stop hit at the same time?
 

·
Registered
Joined
·
672 Posts
i time the cable stops first then draw bow again in draw board and install limb stops after getting timing of cable stops perfect.
 

·
Registered
Joined
·
4,167 Posts
I remove the limb stop altogether. IMO the wall is plenty hard without it.
Agree completely. The cable stops are very solid. Better than any pse I have shot in the past. I find no need for the limb stop. But the limb stop will give the solid feel of some of the binary bows on the market.
 

·
Registered
Joined
·
1,743 Posts
Took mine off cause it got in the way of the fingers on the press never put it back and haven't seen the need to. I run a bomar stop on my vendetta xs ( need to update my signature) and it's as solid as tryin to pull through a phone pole.
So if I ever notice the one on my source get soft I'll put them on it also. But so far haven't seen or felt the need.
 
1 - 6 of 6 Posts
Top