Archery Talk Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
3,073 Posts
Discussion Starter · #1 ·
Are there any special procedures for using this product? Ken
 

· Registered
Joined
·
451 Posts
Ken,

The only recommendation I have is to make sure you prep your shaft by scuffing it up a little, then washing with water and a weak soap solution ( alcohol works for me too), clean paper towel dry. When using Bohning vanes, DO NOT treat the vane.

Scott
 

· Registered
Joined
·
3,073 Posts
Discussion Starter · #3 ·
Scott I am going to be using the usual Flex Fletch vanes on top of wraps. How's your shooting coming along? Ken
 

· Registered
Joined
·
451 Posts
With the Flex Fletch and wraps I don't see any reason you'd need to wipe off the vane. I guess you'd just want to do what you normally do.

As far as the shooting goes... I am improving. My indoor scores are up by about 4 points (Vegas) haven't shot any NFAA yet. The next jump is going to be tough but I am up for it. I am really enjoying the Truespot scope. Aiming has never been so relaxing. Great advice you gave me about giving up on trying to center the target and just look at the X. It worked.

I am anxious to see how the outdoor scores go. I improved my F&H scores by 10 points from average last year but still wasn't feeling I was shooting as well as I should have. Good thing I have a day job!!! How goes it with you?

Scott
 

· Registered
Joined
·
3,073 Posts
Discussion Starter · #5 ·
Been busy as all get out of course. Shootin a lot in the basement 3 or 4 times at 20 yards. 56-59 x's when the body isn't worn out! :D Ken
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top