Archery Talk Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,556 Posts
Discussion Starter #1
just got my new press today. I noticed that when i took the pressure off the strings and cables on my Mission Riot, I had slop in the cams. At the closest edge to the center (axle) there is over 1/32" movement side to side. It is a wobble, not side to side sliding on the axle. Is this common for bushing type cams (i suspect these are bushings instead of bearings due to the new bow cost but am not sure)?. Or, should i take it to the shop where i bought it for warrantee work?

Bow seems to be shooting well except that i frequently get a high or low flyer (about 2" per 10 yd distance). Some times it is me, but too often it happens when i feel i made a good shot.

Appreciate any insight.

Go
 

·
Registered
Joined
·
574 Posts
They are bushing and no it's not normal. Take it in to your Mission dealer for replacements. I just went through that with my
Craze and I didn't get it done soon enough and had the cams bend. It took 10 days for the new cams to come in. At least the warranty covered the replacements.
 
1 - 2 of 2 Posts
Top