Archery Talk Forum banner

Question for the Hoyt Experts

1346 Views 17 Replies 10 Participants Last post by  3DHoytShooter
I have an 2003 Pro Tec I purchased a month or so ago. I just purchased the EZE Laser Tuning Aid tool to get my center shot set-up.

In the instructions it says it can be used for cam alignment. I tried this out and have found that the cams are not aligned. The Laser light on the string at the knocking point drifts off as I rotate it to both cams.

It appears that the top cam (cam.5's) is shimmed in the center of the limb when it needs to be offset to one side to make the string in line with the center shot.

Is this an issue that I should have corrected or is this how it is supposed to be?

Thanks for the help
Bill
1 - 1 of 18 Posts
Get your laser & clamp it to a straight edge or level with a G clamp. Run the laser along the edge to check how accurate it is. I have been through 2 of those lasers & had to adjust the beam to get it right.[Adjustment screws are under the caution sticker] Clamp it to one end & then in the centre of the straight edge when checking it. :D
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top