Archery Talk Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter #1
hey everyone
was planning on doing a custom 82nd and have a couple questions
1. what is the best way to remove the original finish from the alum ie. acid dip, media blast????
2. coating for riser ie powder coating, anodizing,
3. what paints are safe for limbs and he best way to prep them for paint
 

·
Registered
Joined
·
249 Posts
ttt
 

·
Registered
Joined
·
2,703 Posts
chemical stripper on the riser. not limbs methylene chloride will destroy most composites.. scotchbrite the limbs and wash with i.p.a. "rubbing alcohol"
good luck:shade:
 

·
Registered
Joined
·
2,703 Posts
if you have spray equipment and compressor automotive urathane works well "flexible" dont forget to wash the riser use tide and an old toothbrush rinse with water dry wash with alcohol and tack it yer ready to go
 

·
Registered
Joined
·
249 Posts
ttt again
 

·
Registered
Joined
·
1,177 Posts
There are many threads on this subject. Do a little searching on here and youll find lots of good info.
 
1 - 8 of 8 Posts
Top