Archery Talk Forum banner

1 - 5 of 5 Posts

·
Vendor
Joined
·
3,953 Posts
Discussion Starter #1
Hey guys, I just traded for a New Breed Genetix. I am a 28"DL and it says 28.5 on the bow, yet I was told it will do down to 28" or up to 29". I imagine it is based on the draw stops. I just don't know where to set them exactly. Can anyone clarify how to do this on these bows. I am unfamilar with these.

Thanks so much!
 

·
Registered
Joined
·
3,985 Posts
If I am not mistaken there is an extra peg on the cam and you move the string to that peg. I think it will either go down a half inch or up a half inch, but not both. You have to put it in a press to do this.
 

·
Registered
Joined
·
2,335 Posts
Bama is absolutely correct. If you have a BX-4 cam on your bow; it will be 28.5 or 28 depending on which peg the end loops of the string are on. If the string is hooked on the pegs that are closest to the axel; then it is set to 28.5, and if they're on the other peg it's 28. If you have BX-5 cams on your bow; then those are 29-28.5 inch cams, and you can't get down to 28".
 

·
Vendor
Joined
·
3,953 Posts
Discussion Starter #5
Thanks guys...I have the BX-4 Cam and pressed it and put it on the peg fartherest away from axel.
 
1 - 5 of 5 Posts
Top