Joined
·
1,992 Posts
I have some old beman hunter 60/80, 50/70, and I think I have some 400-16's?
What I want to know is, are there charts anywhere that give inside diameter? I still have the old "glue on over the outside" nocks.
I also wondered if it would be ok to use some of the newer slip in nocks with these older shafts?(many are still in their raw shaft state never been shot)
I think I might have a very minimal contact issue with the old nocks. I used to get perfect bullet holes in paper with 2016 aluminums. The carbons shoot almost as good as the XX75's but I can't get rid of a slight high tear.
What I want to know is, are there charts anywhere that give inside diameter? I still have the old "glue on over the outside" nocks.
I also wondered if it would be ok to use some of the newer slip in nocks with these older shafts?(many are still in their raw shaft state never been shot)
I think I might have a very minimal contact issue with the old nocks. I used to get perfect bullet holes in paper with 2016 aluminums. The carbons shoot almost as good as the XX75's but I can't get rid of a slight high tear.
