Archery Talk Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Does anyone know the size/thread of the standard screws to mount a sight?

The screws holding on my sight are stripped and I damaged the sight on my last hunt.:cry: I have to drill out the screws and retap the holes in the riser or buy a new bow. Everything is tuned on this bow and I'd prefer to just have to sight in again and buy a new bow when the 2007s come out.

Thanks for the help.

Bill
 

·
Registered
Joined
·
17,864 Posts
10-24
 

·
Registered
Joined
·
3,005 Posts
If the tap doesn't work for you,meaning if it is stripped out to bad, you could have a local machine shop install heli-coils in the riser.then a regular 10-24 screw will work. Hope this helps.


Ray Ray
 

·
Registered
Joined
·
25 Posts
Discussion Starter #5
Ray Ray that is a great idea. My buddy works of a machine shop and I was going to have him tap it. I'll pass on the suggesstion.

This is going to be my back up bow now. I went to a proshop on Saturday and shot a bunch of bows. Not everything that I was considering, but most of them. I bought a new Bowtech Tribute :). What and easy to shoot, easy to tune bow.
 
1 - 5 of 5 Posts
Top