Archery Talk Forum banner

Sight Picture Question...please help

504 Views 5 Replies 3 Participants Last post by  JustinKansas
Quick question, looking for advice. I am having trouble setting my 10ys pin. When in full draw, my 10yd pin is almost covered by the top ledge of my brace...if that makes sense. Would lowering my peep just a bit help correct that? I do notice that when at full draw, Im having to brace my hand in a different local in order to see threw my peep. I want to try to lower it may 1/2" - 3/4". Do ya'll think that will help? Any input is appreciated.
1 - 2 of 6 Posts
There is no reason for a 10 yard pin on a modern bow with any speed. Just hold your 20 slightly low and go for it. For hunting I don't even worry about 10 yards, I just hold dead on with the 20.
Since the 20 pin will only be about an 1/8" lower than the 10, you will probably have the same issue with it. There are two solutions that I can think of since your sight window is so small.

First, you can move your rest and nock point down so that your vanes just clear the shelf. You can probably buy 1/4 to 1/2" from this and still get the bow in tune.

The second is to raise your anchor a bit and move your peep down.

Hope this helps.
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.