[lunghit]

With a front mount sts can I still have a stabilizer on my bow? Thanks in advance.

 

[WVbowsmith]

yes....the stabilizer will screw into the front of the STS...

J

 

[waldwald]

you can even remove the chrome part of the STS. I simply replaced the screw of my stabilizer with the very long screw of the STS (glued in this chrome part).
Perhaps I can add a photo the next days.

 

[fredbear90]

yes you can but it does add 3/4 of an ich if that matters.

 

[HC Archery]

We put Sims Stealth Cable Dampeners over the Front mount nut. Works kinda like a Sims Node of course.

You need to trim some of the rubber off the C.D.

Unfortuantly, some stabilizers do not let you take out their screw. Sims Modular works well for stuff like this.

 

[automan26]

Here is a pic that should answer your question. This is my front-mount STS on my Hoyt and you can see that my stabilizer works fine.

Automan

 

[waldwald]

here the picture:

http://pixerve.de/26857/STS-direkt.html

 

[kg*archery]

yes you can use a stabilizer but it looks stupiid cause bracket isn't as wide as most stabilizers are in diameter.

 

[ffwildcat]

i have a front mount STS on two of my bows and the long stabiliser mounted to a quick disconnect mounted to the hex bolt on the STS is a less than elegant solution. it works but i'm sure a better mousetrap can be built.

A quick disconnect machined to include the STS block would be a godsend.

i'm so glad my new bow has the rear mount.