It is hard to tell, but yes. It is leaning slightly to the left, or towards the shooter.

It also looks like where your QD knob attaches to the mount isn't on "square", I think thats the word. It looks like its rotated slightly. I'd look there. Make sure its snug and fully into one of the depressions on the bracket.

 

Thank you for the comment. I looked into QD knob as you mentioned. That is where it settles every time I tighten the knob. And yes, it is in the depression on the bracket.

I googled it and found some others have had this issue as well. I might try mounting it upside down on the lower part of the Riser where the 2 piece attachment would go. Just curious if it would sit straight. That might confirm whether it's the top bushing or not.

Thanks for your thoughts. I will keep looking.

 

I really don't like the answer you found. We pay a fair amount for the quality of these products and for it to just be like that, perturbs me. Also, the fact that I just used the word pertrbs, pertubs me... But I digress. It is what it is. Hope you find a resolution, my friend.

As an aside have you tried installing that bracket the other way, flipping it 180°? It may not change anything but if it does, you should know if its the mount on your riser, or the quiver's bracket. Of course, you can always just ignore me, I'm just a weirdo on the internet.

Best of luck!

-Spec

 

Try unbolting the top quiver mount and rotating it.