[Jdub]

Followed JAVI's cam timing guide with success before, but so far the Trykon has been fighting me. I'm sure it's operator error, but never had any trouble getting the timing down before. I started by bottoming out the limbs, turned down the string 10 turns and measured the ATA, I was measuring short @ 32 7/8" (33 3/16" are spec for 30" draw) so I attemted to adjust out to 1/4 inch longer than spec like the guide says but I never could get it to adjust past 33 3/16" (spec) no matter how far I adjusted the buss cable. I turned down the string even more just to make sure and that didn't help. Any ideas?

 

[Tunaboy]

Tryk XL

My brand new Tryk. AtoA is 36 3/16"
Should be 36.5
I also am in the process of trying to bring it to factory specs.
Just started with Javi's paperwork.
I will let you know how it works out.
It does make me mad that an expensive bow is not to spec from the factory.

 

[Tunaboy]

Jdub

Check you message board I sent you one.
I did get my Tryk.XL straightened out.
I actuall spoke to Javi and he explained what I needed to do.
Great guy, helped me understand my bow better.

 

[Jdub]

I finally got everything dialed in, I never could get the AtoA 1/4" over like suggested (which always worked in the past) and while trying to get that to adjust out I got everything all out of wack. I took a break and came back to it with the ATA at spec and started over and took my time and got everything dead on. Now lets see how the fuse string hold up to string creep

Thanks JAVI for all the help you give on here, it's greatly appreciated. :beer:

 

[bassman409]

You didnt mention setting the draw module to the correct tuning setting!

 

[Jdub]

You didnt mention setting the draw module to the correct tuning setting!

The Zephyr Cams are draw specific.

 

[bassman409]

My mistake on the draw lenght!!! What was the fix you made to cure the tuning problem?

 

[Jdub]

As far as Cam timing, I skipped the part adjusting out 1/4" past Axle to Axle and proceeded to adjust timing and everything came into spec and timing.

For actually tuning the bow, read my other post http://www.archerytalk.com/vb/showthread.php?t=365932