Archery Talk Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
672 Posts
Discussion Starter #1
I just purchased a used 2003 cam @ half ultratec off ebay. My question is when I adjust my draw lenght screws to the same holes on the draw lenght modules on each cam the lettering does not line up properly on the cam. Is it possible that lettering could be stamped wrong? Has anyone seen this on thier Hoyts?
 

·
Registered
Joined
·
644 Posts
They will line up a little off but not much. Make sure that the cam you have has a matching module, ie, #2 cam has #2 module. It's possible that they could be mismatched considering you bought it used.There is also two screw holes that you use to adjust the draw and each 1/2 inch change you alternate which hole to use. Matt
 
1 - 2 of 2 Posts
Top