[Akeley Run Archer]

I shoot a vxr 31.5 at 26.5draw length I experienced same nock low tears at initial setup… figured out it was due to nock pinch in my nock set… after i took care of that issue i can now shoot the same arrow in a 250 300 and 340 spine tearing bullet holes in paper

 

[Akeley Run Archer]

Im running gold tip shafts with the gto nock for what its worth ive had good tunes with pierce, ultralights and x cutters in the vxr

 

[Akeley Run Archer]

For what its worth ive also noticed that different release aids change my tune as far as vertical tear goes because of how much pressure is distributed between the top and bottom cam … with a tru ball hbc my arrow sits slightly nock high to bullet hole with an ultraview hinge my arrow sits dead level to bullet hole tear… im guessing the point of the hook being different causes me to pull more on one cam versus the other with the hbc

 

[Akeley Run Archer]

Just a dumb question probably but do you square the ends of your arrow shafts?