[Beaver]

nocking point

Sounds like your nocking pt is low if they are hitting the riser shelf. I would raise it or stick with a slightly lower profile 2" vane.

 

[JRH60]

Is the arrow sitting level with the mounting holes for the rest?

 

[stevezt4]

yea the arrow is level with the hole, and everything lines up level. I hate to switch to a lower profile vane as i like the fusions. The duravane predators did not give me this problem either?

 

[deerman2009]

Sounds like your nocking pt is low if they are hitting the riser shelf. I would raise it or stick with a slightly lower profile 2" vane.

that or check you arrow spine.too weak?

 

[Kill Shill]

you also my not have center shot. is the center of the arrow rest arm 3/4" out from inside the riser?

 

[stevezt4]

im using gold tip xt hunter 5575 and only drawing 62 lbs right now my arrows are 25.5 in long

 

[badbow148]

The profile on the Fusions are a lower one then the Blazers and the Quick Spins Speed Hunters. I think you need to move the rest and nock point up a little and paper tune see where you are from there.