[justin332]

Does anyone have any advise on how I can get the vanes on my arrows to not touch my string by my cable guard without messing up the tunning of my bow?

 

[ecm]

Assuming your rest is set up properly and everything is right....try turning your nocks until everything will clear.

 

[hunterjk]

vanes

I had the same problem with my mathews mission.
The center shot is close to the riser, It's not cut out very much for clerance.
The blazers I was using were stiff and were hitting the cables and riser.
So I ended up switching to 3 in feathers. They would give more
as they pass by the cable and riser.

 

[bassman409]

I had to switch from 5 inch vanes to 4 inch vanes with the new bow. Also as mentioned, unless your arrows have glue on nocks(aluminum arrows) you can rotate the nocks inside the arrow, they are hard to turn, and set the cock vane so it is straight out from the riser.

 

[tracy bullock]

If you shoot a fall away rest or a wisker bisquit you can rotate your nock.You still may have to go to a lower profile vane or even feathers.