Archery Talk Forum banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
5,493 Posts
Discussion Starter #1
Does any one out there know the size of the tiny SAE hex wrench that fits the little screws you use to elevate or depress the ends of the individual pins of a Spot Hogg sight? Each pin has two little bitty screws that raise or lower the end that contains the fiber optic thread - those are the ones I trying to find the proper hex wrench for.

I want to buy a hex wrench set, and want to be sure that tiny one is part of the set.
 

·
Registered
Joined
·
206 Posts
Just Checked and it's a 1/16" on my Grinder.
 

·
Registered
Joined
·
1,501 Posts
i have a 1.5 mm that works ok
 

·
Premium Member
Joined
·
5,493 Posts
Discussion Starter #4
Thanks guys. Either a 1/16" or a 1.5 mm. Got it.
 

·
Premium Member
Joined
·
5,493 Posts
Discussion Starter #6
Thanks, I ordered a 2x pack of 1/16" hex screwdrivers from Amazon. Says they'll be here tomorrow.

Glad to see you got your 20th post by helping me!
 
1 - 6 of 6 Posts
Top