Archery Talk Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
713 Posts
Discussion Starter · #1 ·
Where would I be able to find 125gr
"Glue in" points for the 2312 shaft?

Everywhere I have looked I have found either Eastons which max out at 100gr or the PDP's.
 

·
Registered
Joined
·
719 Posts
funny you sould go on this I just when to a insert so i can ues 125 on my COBALT 2312s did not what to ues the add on wieghts for thay come lose on me and that not good


runawaysXs ttt
 

·
Registered
Joined
·
713 Posts
Discussion Starter · #3 ·
runawaysXs said:
funny you sould go on this I just when to a insert so i can ues 125 on my COBALT 2312s did not what to ues the add on wieghts for thay come lose on me and that not good


runawaysXs ttt
RunawayXs

that is the same reason I am trying to stay away from the add on weights and as for the screw in inserts I have had a few pull out of the shaft in the target so I am hesitant about using those too.
 

·
Registered
Joined
·
719 Posts
o boy i did hot glue my insert in i hope thay stay in or i to will be go to something else i will try these and let you know


runawaysXs
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top