Archery Talk Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
Was wondering how you guys use the markings on the Toxonics sights or how you go about setting up your own yardage markings on the sight? This is my first target sight and know practically zilch about how to set the thing up. I am also having trouble with the threaded scope post loosening and moving. Any help I can get out there would be much appreciated. Nathan
 

·
Registered
Joined
·
9,807 Posts
screw in the threaded scope rod so it is deep into that housing. You need alot of rod sticking out the opposite side of the scope. You will feel the tension increase as it all tightens up.

Then loosen the windage housing and slide it (left or right) to where it is very close to the final position you are seeking. Make small left right adjustments with the adjustment knob as you sight-in.

If you only have a small part of your scope rod sticking out of the housing, you will have problems with it loosening up on ya.

good shooting.

ox
 
1 - 2 of 2 Posts
Top