don't set the first two blades all the way in. put them in half way and insert the third. then push all three down together.

 

Stupid me. I was installing the blades wrong. I was only putting the bent part into the shaft. I now realize that the 120 degree bend goes in the CENTER of the shaft. The instructions on the package are not very clear. After finally figuring it out they assembled easily.

Chalk one up for the stupid newbie.

 

Gordon21 dont feel bad I did the same thing with mine lol I called the proshop I got em from and I said these things just wont go together lol

 

yep i had the same problem when I got them. Took me about 20 min to finally figure out

 

howd they shoot?

 

I got a pack last fall and had to get a tutorial from my nephew after having the same issue. All three have to go together simultaneously, but they are locked in tight when assembled correctly.

 

I, too, would be curious if they shot well for you?

 

At first about 6-8" low. Dead on left to right, but by that time I was pretty well tired. Started work today at 5AM and by 7PM I was pretty well tired. I will try tomorrow when I am better rested. After my initial post, I now feel so stupid. But I guess i got a few friends.........

Once again, when we went inside at 8PM we noticed deer feeding in the back yard while we had been shooting in the front yard. I made another post about that yesterday.

I swear this archery thing is so tough trying to learn off the internet. We finally found a club within a 30 minute drive this past weekend and hope to pick the brains of their members.