Never heard of it but looks like a good one. The factory case is pretty flimsy. Where can you get those from?

 

It's found under the Allen name. I bought one and it fits my Storm and Vision. You will have to check the dimensions to see if it will fit the Scorpyd.https://www.amazon.com/Allen-Contra...019KAQL9Y/ref=sr_1_3?ie=UTF8&qid=1488122621&sr=8-3&keywords=Allen+Crossbow+Case

 

I bought one. Fits my Horton Storm well.

Check the reviews in the site below ... and you can always ask there if anyone has used it with the Scorpyds. One question asked already was does it fit the Scorpyd? One answer to that question was "yes" but didn't say if the replier actually had a scorpyd.


https://www.amazon.com/Allen-Contra...019KAQL9Y/ref=sr_1_3?ie=UTF8&qid=1488125842&sr=8-3&keywords=allen+crossbow+case

 

It's 24" wide. Just measure the width of your bow and you will be all set.

 

That case looks like a beauty I'm interested to know as well

 

I think jerry used to sell them. If it is the one he said it would fit but you had to use the rope cocker to preload the limbs slightly be a use it was a little too tight.

 

Just ordered one! Should be AMD on Wednesday. Will keep yous folks, posted... :thumbs_up

 

I have one for my Scorpyd Extreme. It fits, but it is tight around the cams.

 

Good stuff, B! Mine is scheduled fro delivery sometime tomorrow...

 

I bought one two weeks ago. It fits a Scorpyd Extreme with a small scope (like a TYenpoint Rangemaster), ut is very tight around the cams. If you have a scope like the Vortex XBR mounted high it will not fit this case. It is a shame, since this is a well made case with good looks. If they make it two inches wider and one inch longer with a higher/wider scope extension it would be perfect for the Scorpyds.

With the Vortex scope and a Vendetta mounted on my Orion this case is way too small for it. Looking for a case big enough to fit it.

 

She's definitely a snug fit with the Burris F/F III setup! No issue to zip her up, though. We'll take it...

 

If you add something like a Leupold Vendetta it becomes impossible to zip the case. I am trying to modify this case by adding slits to make room then hand stitch to finish the raw edges.