wheres ATA at ????

from pulling strings out of the package im guessing the first thing you did is install them as they were paper clipped??? no twisting or untwisting first install???

THEN when you said adjusting cables n strings what did you do exactly???

Do you have regular grip on bow or side plates????

 

I had that problem too. Twisted buss until reached peak weight. Then left that cable alone and twisted the string and control for DL. I'm close but probably not quite exact on my DL ATM. I'm new also so its fine for now with me.

 

Ata is 35 7/16 - 1/2 have side plates on bow I put string and cable on and adjusted cables and string to get peak weight, timing, and sync. I'm not really concerned a whole lot about the dl# as much as it shooting right, I shot it about 30 times and noticed the arrow was not flying straight checked it with bare shafts bare shaft hitting nock left arrow point was five inches right at 20yards with 340s and two inches right with 300s

 

Had this problem before with same bow,I twisted the string up and adjusted yokes to correct but it dropped my peak weight so I thought it might need new stringes and cables and that's where I'm at