i just received mine and I'm pretty mechanically inclined , but I'm a little confused on this one , i had no idea i had to drill my Blitz, Can someone with the Zenith upgrade please help me out , they told my when i bought it that it would only take 5 minutes
Kaveman44
Zenith Upgrade for Blitzenburger????
Contact 60X. I sold off my Bitz jigs because they weren't any better than what I had. It was after 60X bought Zenith that I bought the Zenith Kit just in case I latched on to another Bitz.
When you insert your X10 ProTour super expensive SKINNY arrows onto the Zenith post style nock receiver...the FRAME support on the BITZ jig is too deep, at the top of the jig frame. So, Zenith provides an adjustable plate, so you can provide support to the arrow.
Depending on where you decide to drill the holes, make sure that when you are in the MIDDLE of the slot range, you can properly support your X10 ProTour arrows. When I TOP out the plate (plate in lowest position), I can support really FAT diameter arrows.
No need to drill it.Use a small vice grip and clamp it in place.I've used mine this way for several years. I bought one of the originals when joe started selling them.
just worried about where to drill , the template doesn't make me very confident on where to drill
You don't have to be super precise about the drilling. If you have access to a pillar drill it'll be easier but I did mine with a cordless.
Sent from my SM-G920P using Tapatalk
Sent from my SM-G920P using Tapatalk
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
